Payment & Shipping Terms:
|Product Name:||LED Garden Light||Lamp Power:||20W,30W|
|LED Chips:||Lumileds Luxeon 3030||CRI:||>70|
|Whole Lamp Efficiency:||>160Lm/W||IP Rating:||IP66|
|Warranty:||3 Years||Power Factor:||>0.98|
150lm/W Outside Garden Lights,
Luxeon 3030 LED Garden Light
All in one solar LED Garden light 20W with 3 years warranty.
1. The integration of design, no cable, the installation is very convenient.
2. The Mono-crystalline solar panel, LED lights, lithium battery, intelligent controller integrated Aluminum Alloy shell.
3. It used of 18650 lithium battery (lithium iron phosphate battery) fight the high temperature, keep long life.
4. When the products with optically controlled microwave induction infrared sensor, automatic adjustment of intelligent power on rainy days, extend rainy days.
5. It used of alloy material as the main structure, with good rust prevention, corrosion protection.
6. The wireless remote control setting device, adjustable lighting time, lighting power, automatic detection of battery voltage, read light power parameters, a human body induction function, as long as people go through when full power lighting, no automatic power down alf, restore energy saving mode.
7. Time control + light sensor control + motion sensor control
8. Motion and light sensor built in: solar street light goes on at dusk at 20% brightness (Brightness adjustable). Can go from 20% power to full brightness when motion is detected. Three Intelligent Modes: Bright / DIM / Recharge. 1,Bright: motion activates for lighting when motion is detected for security light and to save battery; 2,DIM: 20% lighting for saving power when no motion(Brightness adjustable); 3,Off/Recharge: automatically turns off in daylight and goes into recharge mode. (working mode can be adjusted according to client's demands).
|Battery||18650 lithium battery 12V 20 Ah|
|Color Temperature||Warm White: 2700-3200K||Neutral White: 4000-4500K||Pure White: 5000-6500K|
|Solar panel||30W /18V monocrystalline silicon|
|Chip Brand||LUXEON 3030|
|Operating time||Full power >12 hours ,Intelligent mode 3-4 days|
|Control Mode||Light Control + Motion Sensor|
|Material||Die Casting Aluminum|
1. The ex-factory of the standard components of the LED street lights include a 3*1mm2 cable .The power supply wire should suffer the voltage ≥300/500V,the copper cross-section ≥ 0.75 mm2 of 3 copper wires inside.The installation and wiring connection should be carried out after turning the power off. Before wiring connection,the operator must check the polarity of power supply to prevent the damage of controller fuse and lamp.
2. Insert the street light holder into the pole arm . The diameter of pole arm is 50 mm.The length of connective part is 60-65mm.Adjust lamp to desired level ,wrench the M8 secure screws until tightened.
3. Switch on the power and make sure the light is on.Then the installation is done.
- What about the lead time?
Contact Person: Ada Zhong